Gas springs

MOUNTING CONDITIONS

• The gas spring should not be subjected to transverse load.
• If possible, the maximum load capacity of the gas spring should not be fully utilized.
• If desired to re-paint the gas spring, the piston rod should be covered properly.
• Do not use solvents upon purification.
• Accessories for the Gas spring installation are found on page Gas spring accessories.

INSTALLATION

• Gas springs should be installed the piston rod facing downward.
• The piston rod must be protected against voltage fluctuations, welding and grinding sparks, oxidizing chemicals and paints.
• Never grap the rod with pliers or in a vice without using protective lead, aluminium or copper jaws.

OPERATING CONDITIONS

• Operating temperature: -30ºC - +80ºC
• Maximum number of cycles (full reciprocating motion) / min : 5 pcs

STORAGE BEFORE USE

• Gas springs can be stored horizontally at ambient temperature for up to three months.
• For long-term storage gas springs must be stored vertically with the rod pointing down.